FarmHQ pairs a cellular-connected hardware module with a mobile dashboard so you can start, stop, and schedule irrigation cycles from any phone. Real-time flow readings. Soil moisture graphs. Instant fault alerts.
No rewiring. No electrician. The FarmHQ module connects to your existing pump controller and transmits over 4G LTE.
Start or stop pumps from anywhere with cell signal. The FarmHQ module uses 4G LTE — no Wi-Fi required at the field. Latency under 2 seconds from tap to pump response.
Paired with capacitive soil probes, FarmHQ logs moisture at 15-minute intervals. Charts show field trends across the season — cut water use by dialing in the right run times.
Overtemp, pressure loss, or power failure triggers an SMS to your phone within 60 seconds. No more driving to check on a pump that shut off at midnight.
Set irrigation windows that run automatically even when you're away. Schedules respect pre-set water budgets and pause if the soil probe reads above threshold.
Monthly PDF reports break down pump hours, estimated acre-inches applied, and cost per crop type. Export to CSV for compliance filings with your water district.
Manage up to 20 pump stations from a single app. Each site shows live status: running, idle, or fault. Switch between fields in under a second.
Bolt the weatherproof enclosure to your pump panel. Two wires connect to your existing start/stop circuit — the same connection a manual switch uses.
Scan the QR code on the module with the FarmHQ app. The device registers to your account over 4G LTE — no router config, no port forwarding.
Tap Run on your phone. The pump starts within 2 seconds. Add schedules, soil probes, or additional pump stations at any time from the app.
Command-to-pump latency
Managed in one dashboard
Fault alert delivery
Seed funding from Lowercarbon Capital
Hardware ships in 3 business days. Setup takes an afternoon.